Acid-Base Titration Lab

Acid-Base Titration Objectives 1. To titrate a hydrochloric acid solution of unknown concentration with standardized 0. 10M sodium hydroxide. 2. To utilize the titration data to calculate the grand of the hydrochloric acid. Materials hold in handout for more info. Procedure See handout for more info. Data and Calculations Table 1 Volume of NaOH Required to Neutralize 10. 00mL of Unknown HCl Molarity of NaOh tribulation 1 Trial 2 Trial 3 Trial 4 Initial Volume of NaOH(mL) 0. 0 11. 00 20. 85 30. 45 Final Volume of NaOH(mL) 11. 00 20. 85 30. 45 39. 98 Volume of NaOH used(mL) 11. 00 (Cancel out) 9. 85 9. 60 9. 53 Average Volume of NaOH = (9. 85+9. 60+9. 53)/3 = 9. 66mL Sample Calculations (9. 85+9. 60+9. 53)/3 = 9. 66mL The average volume of NaOH used. Calculations 1. Moles NaOH = M x V = (0. 1M) (0. 00966L) = 0. 000966 moles 2. Moles HCl = moles NaOH 0. 000966 moles - 9. 6610-4 3. NaOH + HCl = NaCl + H2O Moles NaOH = M x V = (0. M)(0. 00966L) = 0. 000966 moles Moles HCl = moles NaOH HCl = moles/volumes = (0. 000966)/ (0. 0096L) HCl = 0. 1M Follow-up Questions 1. It allow have no nucleus because the phenolphthalein only changes color depending on the pH level. Adding substances that will not change the pH level will have no effect. 2. We rinsed out the buret with NaOH, it is to squander any leftover acids that may have existed from previous experiments that the buret may have been used in. 4.When we added the NaOH, it instantly neutralized the HCl but because of HCl having more moles inside the beaker, the trim HCl instantly reverting the system back into a base. 5. HCl = 0. 1M pH = -logHCl pH = -log(0. 1M) pH = 1 Conclusion By using the titration data, we found out that the molarity of HCl is equal to the concentration of NaOH. This happens because the system is in a one-to-one relationship between the two compounds. If we use the same amount of volume of HCl and NaOH, and mix the two, it will reach to a neutral pH value.